![]() In response, the manufacturers of Alarm Signalling Equipment have upgraded their devices to remove the need for a PSTN line. As the NBN is being rolled out across Australia, Telstra are decommissioning the old copper Public Switched Telephone Network ("PSTN") telephone lines. Some Alarm Signalling Equipment (ASE) may be affected by the roll-out of the National Broadband Network ("NBN"). Note: The following information has been derived from publicly available information, and may change from time to time. This key is commonly referred to as the USB style key.ĪDT Fire monitoring can be contacted 24 hours by telephone on 1300 360 575. The Centaur Series II has a similar operation to the Series I however it has fewer alarm inputs and uses a different type of “Key”. This device is progressively being phased out in favour of the Centaur Series II which incorporates Dual SIM Radios, removing the need for a backup telephone line and overcoming issues related to the National Broadband Network. The ASE features THREE types of “KEYS” that provide the following functions The device features up to 8 alarm inputs. The Centaur Series I originally was fitted with a radio modem and a backup telephone line for communicating alarm signals. The two models of the Centaur are very similar in function but differ slightly in terms of their features and functions. Their Alarm Signalling Equipment called the Centaur, Series I and Series II have been around for over 20 years. Specifies requirements, methods of text and performance criteria for fire alarm routing equipment and for fault warning routing equipment for use in fire detection and fire alarm systems installed in buildings.ĪDT Fire Monitoring are the largest provider of monitoring services in Victoria. AS 7240.21-2006 (R2016) - Fire detection and alarm systems Routing equipment.This Standard sets out the requirements for the functional and performance requirements of equipment used to signal status changes at an automatic fire detection and alarm system to a monitoring service. AS 4428.6-1997 : Fire detection, warning, control and intercom systems - Control and indicating equipment - Alarm signalling equipment.The objective of this Standard is to provide fire equipment manufacturers and fire alarm monitoring organizations with a telecommunications protocol for connecting fire alarm systems to monitoring centres, in order to achieve system and equipment interoperability AS 4418.2-2000 (R2016) : Supervisory control and data acquisition (SCADA) - Generic telecommunications interface and protocol - Fire Alarm Systems.There are THREE standards that set out the requirements for the operation, interface and protocol for the operation of Alarm Signalling Equipment
0 Comments
Leave a Reply. |